D. Bamboo carbon far infrared waist belts have health care function

1. The improvement waist micro cycle, invigorates the blood to remove extraverted blood, elimination lumbago, backache;
2. To treats the waist category rheumatism to have the remarkable effect;
3. To the anxious chronic nephritis, the chronic gastritis, the anxious chronic constipation and so on have the assistance treatment function;
4. Effective adjustment reproductive system, improvement month menorrhalgia, the menstruation are out of balance, the premenstrual syndrome and so on;
5. The promotion blood circulation, causes fat piling up place that waist or leg department gives off heat, then the decomposition fat, reduces the size body, Healthy build.
E. Which people need the bamboo carbon far infrared waistband?
1. The acute waist sprains, the chronic strain of lumbar muscles,
2. Rheumatism cause the lumbago,
3. The anxious chronic nephritis, gastritis, the constipation, the menstruation are out of balance and so on sickness,
4. Needs to lose weight woman which likes to look good, the gentleman which the abdomen fat piles up.

Trouble Shooting
(a) If you encounter the problem of "NOT" getting any electrical current readings (THE CURRENT READS ZERO for volts and amps), the first thing confirm is DID YOU ADD SALT… as the current will NOT REGISTER unless SALT is added to the tub water. If you have added Sea Salt and the electrical readings are still showing ZERO then next you should confirm that the WRIST CUFF (wrist band) is on your wrist correctly allowing the Wrist Cuff metal tabs to be in contact with your skin. The two current readings are working best when they show around 1.5amps with 14-15 volts…
(b) Also, MOISTEN the Wrist Cuff CONTACTS that TOUCH to your wrist skin to elevate the Wrist Cuff’s ability to read the electrical current from your wrist skin. NOTE: Similarly, I have a treadmill with a heart rate band (monitor) that goes around my chest, that if I fail to moisten the two metal tabs that touch my chest skin then sure enough, it fails to read my heart beats and shows zero on my treadmill LCD. So remember that Water Moisture helps the conductive properties of electricity.
? Is the WRIST CUFF plugged in the wrong place? The Wrist Cuff does "NOT" plug into the BACK of the machine it plugs in the FRONT, right beside the Array plug. The Wrist Cuff COMPLETES THE ELECTRICAL CIRCUIT (the circle of current from your body at the feet through the machine through the wrist cuff and back to the feet and again up through the machine around in a circle)… Therefore if any part of the Circuit is loose or not making PROPER CONTACT, then the LCD will show ZERO…also, no salt will cause a zero AMP reading.
(d) Please apply between a HALF and one full TABLESPOON of SEA SALT to start with, and you will notice as you sprinkle in more salt, the AMPS will rise, so add salt until you come to approximately 1.5 AMPS as the reading on the console. We have had customers tell us that ONLY Sea Salt works (you can get it at any Wal-Mart or Grocery Store in the salt & pepper section) to further assist the conductive electricity as well as TOXIN release from your body. Sea Salt does NOT contain Iodine added but regular table salt does, so Sea Salt is best.
(e) Just to further clarify, the FIR Heating Belt (Pad) that you wrap around your stomach is what plugs into the BACK of the machine. This FIR BELT-PAD is supposed to be worn to WARM THE BLOOD in your body to improve blood flow and to further assist in releasing the TOXINS from your BLOOD and out through your feet. The FIR Heating Belt plugs into the BACK SIDE of the main Console Unit, not the front.
(f) If you happen to push the WRONG PLUG JACK into the wrong plug-in outlet hole in the Machine Console and damage the